(10 years, 1 month ago)
Grand CommitteeMy Lords, I will briefly support the amendment in the name of the noble Lord, Lord Hodgson. He has made an even better case than the one that was presented to him in the first case. It struck me that in principle, if we set our minds to it, we could probably find quite a number of other areas apart from double-glazing, which was the example that the noble Lord gave, where goods are manufactured, bespoke, to a customer’s requirements. This particular case is very strong because of the construction work that is required to be done, which you cannot undo without serious damage to a property. I therefore hope that the Minister can give either clarification or assurance that something in the Bill deals with these kinds of made-to-measure products. A very valid point has been raised, and the noble Lord, Lord Hodgson, has put the case extremely well.
My Lords, the amendment as it is written, not necessarily as it is intended, is what concerns us. As written, it would undermine the right to reject. We do not see why a consumer should have any less of a remedy when something has been made to their specification than anything else. In fact, very often if it is made to their specification it may be particularly valuable, desired and even expensive. They certainly should not lose their rights just because of that. To some extent their rights should be stronger. because they have negotiated and explained exactly what it is that they want. As I was saying to the Minister earlier, I am wearing a made-to-measure garment.
My Lords, I shall speak also to Amendment 20B. I am afraid that I am going to do exactly what the noble Baroness, Lady Hayter, did not want to do, which is to question the “one repair” point. I return to some of the concerns of the motor industry. The Society of Motor Manufacturers and Traders and the National Franchised Dealers Association have raised significant concerns over the wording of Clause 24 regarding “one repair” and the right to reject the product and demand a refund. These concerns are centred not on the principle of the right to repair or replacement itself but rather specifically on what “one repair” entails. This issue is of course particularly pertinent to the final right to reject in Clause 24.
At present the Bill does not specify what “one repair” would entail but the draft guidance states that one repair means a single attempt at repair and that the trader can offer further repairs and replacements, but only if the consumer agrees. Members of the motor industry and the trade seek clarity over the definition of “one repair”, and do not accept that the current status of the draft guidance provides a fair interpretation of what is really needed to give clarity. They point out that the notion of a single attempt at repair, as set out in the draft guidance, is problematic for highly complex consumer goods such as motor vehicles. They say that these complex products may show a fault that requires more than one repair, involving a series of visits to the garage so that the fault can be diagnosed and tested, and have causes ruled out. In addition, a repair may appear complete but the fault may reappear, as can be the case with electrical faults, and a second or subsequent repair may fix the problem. These issues are likely to become increasingly apparent as motor vehicles become even more technologically complex, as they have done over the past few years.
The amendment seeks to include a definition of “one repair” to permit a process of repair and provide traders and dealers with a fair opportunity to fix these complex goods. It is worth noting that the consumer will still be fully protected by the right to repair or replacement under the amendment, as the process of repair would still need to be completed within a reasonable time and without significant inconvenience to the consumer. I hope that at least meets the interest of my noble friend, as this is a matter of considerable concern. On the previous amendment to which I spoke while seeking further clarification on the guidance, I note that my noble friend answered the second point about the CCA but not the first: what clarification the guidance would give for minor defects. Perhaps my noble friend can write to me on that matter. In the mean time, I beg to move.
We think that the noble Lord has brought an interesting issue to the Committee; I do not know whether the Government find it such. However, we are unconvinced that this needs to be detailed in the Bill as suggested. The Bill simply states that repair means making the goods conform to the contract, which means making them deliver what was promised. I do not think that it says “at one go”. Obviously, we look forward to hearing what the Minister will say on that.
However, the Committee will not be surprised that our worry is that the danger of the new wording is to allow a trader to make more than one repair and then claim that it was simply different stages of the same job, whereas actually they may have tried this, that and then something else—and want another go if they did not do it at first. I recognise that that is not what the noble Lord, Lord Clement-Jones, is aiming at, but the wording might allow for that. It is exactly to avoid such situations where consumers are fobbed off by a number of unsuccessful repairs before they can move to the next stage that we like the clarity of the Bill and would not want it jeopardised by these amendments, no matter how well-intentioned they might be.
As we are into personal stories, such as my clothes, let us take my new car. Of course, it got a great big problem and I took it back to Nick but rather than opening the bonnet all he did was to put a computer on top of the car, which seemed to tell him what was wrong. I do not know how that worked but 55 minutes later it was completely mended. Cars, which I no longer understand even if I once did, may be more complex but one does not want to have to keep going back to the trader. We worry that the amendment would lose the clarity that there is in the Bill.